D-Link EyeOn Pet Monitor HD 360 Guide D'installation page 6

Mounting your camera (optional)
1
2
3
4
5
6
4
• Place the mounting bracket where you want to
position the camera and use a pencil to mark the
holes.
• Depending on the material of the wall or ceiling,
use proper tools to drill two holes 25mm deep with
a 6mm drill bit where you marked. After drilling
the holes, insert the plastic anchors to support the
screws.
• If desired, the cable can be concealed behind the
mounting bracket. Run the cable through the back
of the mounting bracket, securing it with the built-
in guides. Be sure to leave enough cable length
protruding to allow connection to the camera.
• Fasten the mounting bracket to the wall using the
screws provided.
• Using the supplied thumbscrew, fasten the camera
to the mounting bracket. Connect the power cable
to the camera.
• Adjust the angle of the arm on the mounting bracket
as required. Tighten the thumbscrew to lock the arm
in place.
DCS-855L