Télécharger Imprimer la page

Samsung WF53BB89A Serie Mode D'emploi page 63

Masquer les pouces Voir aussi pour WF53BB89A Serie:

Publicité

Les langues disponibles

Les langues disponibles

Problem
Excessive suds.
Cannot add additional
detergent.
Stops.
Fills with the wrong water
temperature.
Untitled-4 63
• Make sure you use the recommended types of detergent as appropriate.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Reduce the detergent amount for soft water, small loads, or lightly
soiled loads.
• Non-HE detergent is not recommended.
• Make sure the remaining amount of detergent and fabric softener is not
over the limit.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door, and tap and hold
the washer will not tumble or spin unless the door is closed.
• Before the washer starts to fill, it will make a series of clicking noises to
check the door lock and will do quick drain.
• There may be a pause or soak period in the cycle. Wait briefly, and the
washer may start.
• Make sure the mesh filter of the water supply hose at the water taps is
not clogged. Periodically clean the mesh filter.
• If the washer is not supplied with sufficient power, the washer will
temporarily not drain or spin. As soon as the washer regains sufficient
power, it will operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush water
lines.
• Make sure the water heater is set to supply a minimum of 49 °C hot
water at the tap. Also, check the water heater capacity and recovery
rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter may be
clogged.
• While the washer fills, the water temperature may change as the
automatic temperature control feature checks incoming water
temperature. This is normal.
• While the washer fills, you may notice just hot and/or just cold water
going through the dispenser when cold or warm temperatures are
selected. This is a normal function of the automatic temperature control
feature as the washer determines the water temperature.
Action
to start the washer. For your safety,
English 63
2022-12-22
4:12:50

Publicité

loading

Ce manuel est également adapté pour:

Wf46bg65a serieWf46bg6500avus