Publicité
Les langues disponibles
Les langues disponibles
12.11 Installation
Checking the wall
Check whether the wall is vertical and has sufficient
1.
load-bearing capacity.
The maximum weight of the appliance is 16 kg.
Drill the hole depth in accordance with the length of
2.
the screws.
The wall plugs must have a secure grip.
The enclosed screws and wall plugs are suitable for
securing the appliance to the following walls: Solid
brickwork, plasterboard, porous concrete, poroton
bricks.
Note: When drilling holes, always check the wall's sta-
bility before the unit is attached to the wall. If the wall is
not sufficient stability, the appliance cannot be moun-
ted.
Preparing the wall
Ensure that there are no electrical wires, gas pipes
1.
or water pipes in the area where holes are to be
drilled.
Cover the hob to prevent damage.
2.
Mark a vertical centre line on the wall from the ceil-
3.
ing to the lower edge of the appliance.
Centre the angle brackets using the centre line.
4.
The centre of the angle brackets is marked with a
notch.
Align the angle brackets horizontally.
5.
Mark the holes for the angle brackets in the flue.
6.
Mark the holes for the appliance bracket.
7.
370
Drill the holes.
8.
Insert the wall plugs flush with the wall.
9.
Screw on the angle bracket for the flue duct.
10.
Screw in the screws for the appliance bracket
11.
loosely; do not tighten them fully.
Preparing the appliance
Remove the grease filters.
1.
To avoid causing damage, do not bend the grease
filters.
Secure the air pipe connector to the appliance.
2.
Installation instructions en
13
Publicité
