francky-shop PREMIUM 6m Série Mode D'emploi page 23

6 m series
GB
Instructions
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. In colder weather conditions we suggest to bring the roof to room temperature
before installing.
1
Assemble the roof frame by mounting parts 6 to 11 on the pipes (parts 1 and 2).
Use the screws to attach the parts.
2
Attach the reinforcement braces (parts 4 and 5) using screws (19) and wing nuts (20).
3
Lift one side of the tent frame and attach the legs (3). Place the roof (26) onto the frame
and use the bungees (22) to fasten it.
Be sure not to put too much tension on the bungees in order not to make attaching the
other side more difficult.
4
Attach the legs on the other side and install the feet (12, 12a and13) at the bottom. Make sure,
that the leg pipes are in vertical position, to avoid overtention on the endwalls. Attach the
side covers to the pipes (3) using hooks (25). Complete the bottom frame with the required
pipes (2) and connector (14). Use the long ground pegs (16) to fasten the legs to the ground.
5
Unfold the side walls (27) and the end walls (28) and attach the side walls to the frame using
the bungees (22). Attach the end walls directly to the roof using the short bungees (23).
Use the short ground pegs (17) to fasten the end walls to the ground. The guy rope runs from
every corner of the tent and is braced using the screw hooks (15).
premium
23