Replacing The Lamp; Technical Specifications - Velleman VTLAMP3WNU Mode D'emploi

5.

Replacing the lamp

1. Unplug the device from the mains and let the fluorescent lamp
cool down before replacing it.
2. The lamp is located behind a plastic diffuser.
Place a small flat screwdriver between diffuser and housing as
indicated [1]. Gently push on the screwdriver. Lift this end of the
diffuser [2] and slide [3].
3. Carefully pull the defective lamp from its socket.
4. Install a new lamp (type PL 9W 2G7, order code LAMP09PL/2) into
the socket.
5. Put the diffuser back.
Caution: If the plastic diffuser is damaged, disconnect the lamp immediately from the mains. The diffuser is
not replaceable. Do not use the lamp with a cracked or broken diffuser.
6.

Technical Specifications

diopter
color
light color
color temperature
energy consumption Ec
intensity
power consumption
power supply
spare lamp
cable length
dimensions:
Use this device with original accessories only. Velleman Inc. cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.vellemanusa.com.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Inc.. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 07/10/2014
VTLAMP3WNU
3 (magnification 1.75x)
white
cold white
> 6400 K
18 kWh/1000h
510 lm
18 W
110 Vac / 60 Hz
-
± 4.27 ft / 1.3 m
arm length: ± 33.86 in / 86 cm
glass: ± 7.28 x 6.1 in / 185 x 155 mm
weight: ± 7.94 lb / 3600 g
spare magnifying glass cover: VTLAMP3WN/SP1
4 ©Velleman Inc.