Warnings And Caution; Warranty; Limitation Of Responsability; Safety Instructions - Studer Innotec X-Connect Multi Xtender Manuel D'assemblage

Studer Innotec
W
ARNINGS AND CAUTION
1 8 B
W arranty
3 7 B
Studer Innotec issues on this product, which they have manufactured and offered for sale, a two
year warranty against any material defect or manufacturing fault from the date of despatch by an
agreed Studer Innotec distributor.
Any warranty claim will be refused if it is not sent back to the point of sale, or another place
indicated by Studer Innotec, in appropriate packaging and accompanied by a copy of the dated
proof of purchase.
No warranty claims will be accepted for damage resulting from handling, usage or processing that
does not explicitly appear in this manual.
Cases of damage arising from the following causes are notably excluded from the warranty:
• Inappropriate use
• Oxidation resulting from condensation
• Damage resulting from falls or mechanical shocks
• Damage from transportation due to inappropriate packaging
L imitation of responsability
3 8 B
The placement, commissioning, use, maintenance and servicing of the mounting frame X-Connect
cannot be the subject of monitoring by Studer Innotec. For this reasons Studer Innotec assumes no
responsibility and liability for damage, costs or losses resulting from an installation that does not
conform to the instructions, defective functioning or deficient maintenance.
The use of Studer Innotec devices is the responsibility of the customer in all cases.
Studer Innotec does not assume any responsibility for the infringement of patent rights or other
rights of third parties that result from using the devices.
The responsibility of Studer Innotec may not under any circumstances exceed the amount spent to
purchase the product.
Studer Innotec reserves the right to make any modifications to the product without prior
notification.
S afety instructions
3 9 B
Carefully read the following safety instructions in order to avoid any injury or risk of damaging this
product and those that are connected to it.
Only use the connections cables specified and supplied by Studer Innotec. Under no
circumstances should you use a damaged cable. In case of doubt about the condition of this
device, it should be inspected by a qualified technician.
Do not use the mounting frame X-Connect in a humid environment.
8