Blackstone Adventure Ready 2341 Manuel Du Propriétaire page 6

OWNER'S MANUAL | ASSEMBLY GUIDE
Remove the griddle stand from the packaging and open the
STEP 02
stand legs� once the legs are fully open, the locking pins will engage�
(To close the legs, pull on the locking pins to disengage them�)
locking pin locking pin
Make sure the front pins are fully
Attach the side shelf by sliding the tear-shaped holes over
STEP 04
seated in the holes, then push
the pre-inserted screws on the right side of the griddle stand� Push
the griddle top forward to lock
the shelf down to lock it into place�
the griddle in place�
Make sure the front pins are
seated in the holes, then push
the griddle top back�
Hang the grease cup in the slot on the back of the
STEP 06
griddle body�
Place the griddle top onto the griddle body by aligning the four pins
to the holes of the body�
❶ ❶ Place the two front pins into
the front locking holes and push
the griddle top back�
❷ ❷ Then, set the two rear pins
into the rear holes�
06
Adjust the legs to desired height and turn the thumbscrews
STEP 03
to tighten� (Count the divots to achieve even heights�)
Make sure the front pins are fully
Place the griddle on the stand� The four (4) feet on the
STEP 05
seated in the holes, then push
bottom of the griddle will line up with the corresponding holes for
the griddle top forward to lock
secure placement�
the griddle in place�
Make sure the front pins are
seated in the holes, then push
the griddle top back�
❶ ❶ Place the two front pins into
the front locking holes and push
the griddle top back�
❷ ❷ Then, set the two rear pins
into the rear holes�
❷ ❷
❶ ❶
Model: 2341
BLACKSTONEPRODUCTS.COM/SUPPORT