Anker PowerConf Mode D'emploi page 2

Important Safety Information
• Avoid dropping.
• Do not disassemble.
• Do not install near any heat sources.
• Do not place any sources of danger on this device (e.g. liquid filled objects, lit candles).
• Use original or certified cables.
• Clean with a dry, soft lint-free cloth. Do not use any corrosive cleaner or oil.
• Do not expose batteries to high heat such as direct sunlight, fire or the like.
Notice
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.For the
declaration of conformity, visit the Web site:
Due to the used enclosure material, the product shall only be connected to a USB Interface of
version 2.0 or higher.
Do not use the Device in the environment at too high or too low temperature, never expose
the Device under strong sunshine or too wet environment.
The suitable temperature for the product and accessories is -10~40℃ .
When charging, please place the device in an environment that has a normal room
temperature and good ventilation.
It is recommended to charge the device in an environment with a temperature that ranges
from 5℃ ~25℃ .
RF exposure information: The Maximum Permissible Exposure (MPE) level has been
calculated based on a distance of d=20 cm between the device and the human body. To
maintain compliance with RF exposure requirement, use product that maintain a 20cm
distance between the device and human body.
uk.anker.com
01 EN