Introduction; Capabilities Of The Rs-P26 Printer; Overview Of Functions; Startup Procedure - Mettler Toledo RS-P26 Mode D'emploi

1 Introduction

1.1 Capabilities of the RS-P26 Printer

The RS-P26 is a simple to operate dot matrix printer for METTLER TOLEDO balances with an RS232C
interface. The printout on normal paper meets the requirements of modern quality assurance sys-
tems (GLP, GMP, ISO 9001, etc.). These norms define the principles and user requirements related
to measuring and test instruments. The RS-P26 complies with the requirements of measurement
traceability by precisely documenting the origin of data, as well as calibration procedures. It meets
the requirement of archiving measurement results by providing a thermally stable and light resistant
printout. When connected to METTLER TOLEDO balances, the RS-P26 prints all data sent by the
balance without restriction, which are not only weight values and calibration procedures, but also
the results of all applications, built into the balance.

1.2 Overview of functions

2 Startup procedure

2.1 Safety measures

The RS-P26 has been tested for the connections and intended purposes documented in these
Operating Instructions. However, it is your responsibility to perform the necessary tests related to
the methods and purposes of its intended use. Therefore, you should observe the following safety
measures.
• The RS-P26 Printer must be used indoors only, and never in hazardous
• The electronics of the RS-P26 Printer are protected against the ingress of
• Comply with cleaning instructions (see section 6.3), protect power plug
• Never open the printer housing. If you have any problems with your printer,
Printing of weight
values
Date and time
Zeroing/Taring of
balance
areas.
splashing water and dust. However, since the printer housing is not water-
tight, the printer should not be used in the presence of liquids.
against wet conditions.
please contact your responsible METTLER TOLEDO service.
The RS-P26 prints out only the stable
weight value
Selected as an option with date and time
in the record header (stored with battery
back-up)
Zero/Tare the connected balance at any
time.
RS-P26 Printer
5