Introduction; Startup Procedure; Safety Measures - Mettler Toledo BT-P42 Mode D'emploi

1

Introduction

What are the capabilities of the BT-P42 Printer
The BT-P42 is a rugged and simple to operate dot matrix printer for METTLER TOLEDO balances
with an a wireless Bluetooth
modern quality assurance systems (GLP, GMP, ISO 9001, etc.). These define, among other
things, the principles and duties for the user of measuring instruments or inspection, measuring
and test equipment. The BT-P42 complies with the principle of traceability of measurements by
precisely documenting the origin of data, as well as calibration procedures. It fulfills the
obligation to archive measurement results by its thermally stable and lightfast print. On
connection to METTLER TOLEDO balances, the BT-P42 prints all data sent by the balance
without restriction, that is not only weight values and calibration procedures, but also the results
of all applications, built into the balance.
2

Startup procedure

2.1

Safety measures

The BT-P42 has been tested for the connections and intended purposes documented in these
Operating Instructions. However, this does not absolve you from the responsibility of performing
your own tests of the product supplied by us regarding its suitability for the methods and
purposes you intend to use it for. You should therefore observe the following safety measures.
®
interface. The printout on normal paper fulfills the requirements of
• The BT-P42 Printer may be used only indoors and on no
account in hazardous areas.
• The electronics of the BT-P42Printer are protected against
the ingress of splashing water and dust. However, as the
printer housing is not tight the printer should not be used in
the presence of liquids.
• Comply with cleaning instructions (see item 5.3), protect
power plug against wet conditions.
• Never open the printer housing. Should you ever have
problems with your printer, please contact your responsible
METTLER TOLEDO dealer.
BT-P42 Printer
3