Weitech BIRD LAZZZER Mode D'emploi page 14

must be observed, certified installation equipment must be used, and
the appliance must undergo regular safety inspections.
Make sure the area below the installation site does not contain any itinerant persons during
installation work, dismantling or maintenance.
Place the appliance in a well-ventilated position, well away from any inflammable materials or
liquids. The appliance must be installed at least 50 cm from any walls.
The appliance must be out of reach of the public, and away from areas where the public
passes by, or to which the public has access.
Before starting installation, ensure that the area for installation will support a local point at
least 10 times the weight of the appliance.
Always use a safety cable capable of supporting 12 times the weight of the appliance during
installation work. This second safety cable must be installed in such a way that no part of the
appliance can fall more than 20 cm if the main support fails.
The appliance must be fixed securely. A rocking installation is dangerous and should not be
entertained!
Do not cover the air-vents in order to prevent any risk of overheating.
The user must ensure that technical and safety installations are duly approved by an expert
before using for the first time. Installations must be inspected every year by properly qualified
personnel in order to ensure maximum safety.
CAUTION: HARM TO THE EYES: always position the laser in
such a way that no one will gaze directly into the laser beam. Ensure
that the beam will not affect the public.
HOW TO ADJUST AND USE THE LASER
- This appliance is intended solely to scare off birds. It is not to be put to any other
kind of use.
- The laser is more effective in darkness. It is therefore advisable not to use it by day.
- Regular breaks in use are essential to maximise the working life of the appliance,
as it is not designed for continuous use.
-
Do not switch the power on and off at rapid intervals, as this will reduce the working
life of the laser cell.
- Always disconnect the appliance from the mains if it is out of use for a long period.
- In the event of a serious operational problem, shut the appliance down and contact
your retailer immediately.
-
Important: never gaze directly at the laser! Do not use the appliance in the
presence of any persons who suffer from epilepsy.
Useful tip: each time you turn the appliance on, the motors will return to their 'initial' position
by default, which means you will hear some noise for a few seconds, after which the
appliance will be ready to function normally.
The BIRD LAZZZER operates completely automatically. No setting or adjustment is required.
The appliance functions in such a way that the laser beam uses the maximum available
space. The rapid movement of the laser beam frightens birds, making them take flight.
The BIRD LAZZZER is programmed to operate for 900 seconds (15 minutes), then pause for
900 seconds (15 minutes). During its active phase, the laser beam will scan at random in any
and every direction. It is normal for it to go out from time to time. After 900 seconds (15
minutes) of action, the laser beam will go out for 900 seconds (15 minutes) for its resting
phase. The monitor lights on the appliance will continue to function: the blue 'laser' monitor
will flash, and the ventilator will continue in operation in order to cool the internal components
of the appliance. After 900 seconds at rest, the appliance will resume its activity cycle.
It is inadvisable to use the appliance during daylight hours as this limits its effectiveness. The
appliance is much more effective when operating in twilight, or at night, than in broad daylight.
MAINTENANCE
- Make sure the area below the installation site does not contain any itinerant
persons during maintenance operations.
-
Turn off the power-supply, disconnect the power cable and wait until the appliance
has cooled down.
The following points must be checked during inspections:
- All screws used to install the appliance and its components must be securely fixed
and must not be corroded.
- Supporting fixtures and structures (ceiling, girders, suspension) must be completely
intact and show no distortion or buckling.
- If a vision lens is visibly damaged (i.e. deep cracks or scratches), it must be
replaced.
BIRD LAZZZER V20062011