Télécharger Imprimer la page

Schumacher Electric SC1360 Manuel D'utilisation page 11

Publicité

Les langues disponibles

Les langues disponibles

PROBLEM
The charger will not
turn on when properly
connected.
I cannot select a 6V or
12V setting.
The display shows
"bAD / bAt / F01 ".
The display shows
"SUL".
The display shows
"bAD / bAt / F02".
The display shows
"bAD / bAt / F05".
14. BEFORE RETURNING FOR REPAIRS
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number
from Customer Service at Schumacher Electric Corporation.
15. SPECIFICATIONS
Input voltage ..................................................................................120V AC @ 60Hz, 3.6A
Output voltage........................................................6V or 12V, with Auto Voltage Detection
Output current rating ............................................................ 2A @ 6V DC; 15A @ 12V DC
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
Battery is defective.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
The battery voltage is still
below 10V (for a 12V battery)
or 5V (for a 6V battery) after 2
hours of charging.
The charger has detected a
sulfated battery.
Desulfation was unsuccessful,
after 10 hours.
Lack of progress is detected
after 12 hours in Maintain mode.
If these solutions do not eliminate the problem,
or for more information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
Monday-Friday 7:00
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
Have battery checked.
No problem; this is normal.
The battery may be defective. Make
sure there are no loads on the
battery. If there are, remove them.
If there are none, have the battery
checked or replaced.
The charger will go into desulfation
mode. If the desulfation is not
successful after 10 hours, the
charger will go into abort mode.
The battery may be defective. Have
battery checked or replaced.
The battery won't hold a charge.
May be caused by a drain on the
battery or the battery could be bad.
Make sure there are no loads on the
battery. If there are remove them.
If there are none, have the battery
checked or replaced.
to 5:00
CST
am
pm
• 11 •
SOLUTION

Publicité

loading