audiophony MOJO CURVE XL Guide De L'utilisateur page 15

MOJOcurveXL - Active curve array system with mixer, BT and DSP
4 - DSP
4.1 - Level bargraph :
The display show the of each 4 channels and of the Master.
This allow you to visualize the signal and adjust the input level. There you can see also if the Limiter is activated.
4.2 - Menus :
Caution, when the system is operating at full power, too high an equalization setting can harm the amplifier.
Limiter threshold
Channel level
High adjustement +/- 12 dB at 12 kHz
Mid adjustement +/- 12 dB on the frequency choosed below
Setting of the Mid frequency adjustement
From 70Hz to 12KHz
Low adjustment +/- 12 dB at 70 Hz
MUSIC : This equalizer setting is almost flat
VOICE : This mode allows to get more clear voices
DJ : This preset makes the bass and high more punchy.
OFF : No cutting
Low cut frequencies choice : 80 / 100 / 120 / 150 Hz
OFF : No delay
Adjustment of the delay from 0 to 100 meters
OFF : The Bluetooth
receiver is OFF
®
ON : Switch ON the Bluetooth
When the Bluetooth® receiver is active, search for the device named
MOJOcurveXL on your Bluetooth® device to pair it.
TWS : Allow to connect another MOJOcurveXL in stereo by Bluetooth
Master level and limiter
receiver and send to channel 4/5
®
English
indicator
®
Page 15