Publicité
Towel Warmer Installation Procedure
STEP 2
Installation Instructions (see figure 3)
1. Check all items have been received. You should have Towel Warmer and mounting bracket kit. Read all instructions before
continuing.
2. Fix wall supports "B" including collar "A" to the wall using the screws provided and in locations as shown on figure 2.
3. Screw the threaded pin "C", into the threaded bushing "D".
4. Hang and adjust the Towel Warmer using set screws "E" to lock pin "C" in the wall bracket "B". Ensure the Towel Warmer is
firmly and safely fixed.
STEP 3
Valve Connection (see figures 5, 6, 8 or 9)
1. If using a hydronic installation pack, slide escutcheon (supplied with hydronic installation pack) over 1/2" supply pipe.
2. Unscrew male threaded components including collars from valve and thread into female inlets at bottom of towel warmer
using a 12mm allen key wrench.
3. Push compression fitting on to 1/2" supply pipe and tighten 1/2" compression fitting collar on valve.
4. Seat male threaded component (now connected to towel warmer) on valve and tighten collar.
5. Insert blank plug and air vent plug (supplied with bracket kit) into top female inlets on towel warmer.
6. Check for leaks and bleed system if necessary using air vent plug.
Warning: All hydronic plumbing connections should be made in accordance with local and national plumbing regulations. It
is the responsibility of the plumber to ensure plumbing system and towel warmer installation comply with these regulations.
Hydronic towel warmer should be used only on a closed system incorporating an anti-rust inhibitor
Figure 3
877-757-8930
www.icobath.com
Publicité
