Fellowes Array AR2 Guide D'installation page 3

4
Pull filters out by the straps and set aside
for now.
7
Lift and rotate unit before setting door-side down
on the provided trays. Determine which electrical
knockout will be used and remove it.
WARNING: do not place directly on any flat
surface as this will damage the sensor that sticks
below the bottom surface.
9
Secure the hooks from the provided
aircraft cabling to the housing through the
mounting holes.
5
Remove mounting hardware and verify included
part quantities.
8A
Loop open end of cables through intended
support or hardware.
Use provided cable clutch hardware to secure
each cable.
10
Have one or two people slowly lifting the
machine while the other pulls the free end of
the cables to keep them taut.
Alternate slowly raising each side to keep the
unit relatively level during lifting.
WARNING: During lifting ensure hooks stay
oriented correctly and do not get misaligned or
they may not hold properly.
CAUTION: To reduce the risk of injury to
persons, install fan at least 2.1 m (6.9 ft) above
the floor.
6
Close the door until a click is heard. Depending on
type of ceiling, attach proper mounting hardware
above installation area per local regulations for
supporting a 92 lb (42kg) fixture. Ideally the
mounting locations would be at the four corners of
a 23" x 46" rectangle.
8B
Remove cross-tee where unit will be installed.
11
Raise the unit until the top of the housing is just
below the grid.
NOTE: If unit is raised too high, have one person
raise the unit while the other depresses the
spring section on the wire clutch, allowing the
cable to be loosened.
3