Aroma Function - ready2music UV STERILIZER Mode D'emploi

Disinfection function
Disinfect household items and small electronic devices such as
smartphones or in-ear headphones as follows:
1. Open the upper lid of the UV sterilizer
2. Place the object in the middle of the opening
3. Make sure that the object is at least 1 cm away from the
edge and does not cover the UV LEDs
4. Close the lid and briefly press the button to switch to disin-
fection mode, the status LED lights up green.
5. Press the button again to start the disinfection. You will
hear a signal tone.
6. After 5 minutes you will hear 3 short signal tones, the status
LED flashes 3 times and goes out. Disinfection is complete.
INFO: INFO: If you open the lid during disinfection, disinfection is
stopped and the UV LEDs switch off to protect your eyes. To continue
disinfection, close the lid.
INFO: Disables 99.9% of bacteria and viruses on the surface
(e.g. influenza, E.Coli, Staphylococcus Aureus) during a complete
program run.
1. close
16

Aroma function

Before using the disinfection function, place a drop of essential
oil in the opening of the diffuser to use this function. (Optional)
Then start the disinfection as described on the left.
(Essential oils not included in the scope of delivery)
1 drop
2. press
EN
17