Safety Instructions - ready2music UV STERILIZER Mode D'emploi

Safety Instructions

To avoid the risk of fire, electric shock, damage to the device or
injury, please observe the following safety instructions:
This device has a wireless charging area on the lid. Do
not place metal objects on the lid!
Before charging, remove metallic protective covers or
magnetic holders from the phone. Do not place magnetic
or metal objects on the charger. Doing so may cause
overheating and damage.
This device contains several LEDs and ionizers which emit
UV radiation and ozone.
The device has an automatic switch-off when opened.
Do not attempt to bypass it or tamper with the unit. Do
not look directly at the UV LEDs.
Place the unit at least 1 m away from electronic
equipment to avoid interference.
The device generates a small amount of heat during
induction charging. Place the unit in such a way that
sufficient ventilation is ensured. If the unit heats
up abnormally, please allow it to cool down before
continuing the charging process.
14
Do not expose the device to direct sunlight or tempera-
tures above 40 or below 0 degrees Celsius.
Do not hold the unit directly or in the vicinity of naked
flames such as candles or similar. Do not use the unit
during a thunderstorm.
Do not expose the unit to liquids, moisture or dust. Do
not use water, alcohol or chemicals to clean the unit.
Before cleaning the unit, remove the unit from the
power source.
Do not throw or drop the unit as permanent defects
may occur. Press the buttons on the unit only with
moderate force.
Please do not try to open the unit or repair it yourself.
Instead, contact your dealer or a qualified technician.
If you have problems with your unit, please contact the support
hotline on page 20.
EN
15