Applications - Swatch CORDLESS II Mode D'emploi

Q R
UICK EFERENCE
A
CTIVATION
Inserting the batteries into the handset
To remove the battery compartment cover (2), press it lightly (as
shown) and slide it downwards.
Insert the 3 batteries (as shown in Fig. 1) into the battery
compartment. Make sure the polarity of the batteries is correct
(3).
Slide the battery compartment cover back over the batteries until
you hear it snap into place.
Please note: The following battery cells are approved for the
handset:
NiCd AAA: • Panasonic: P-25 AAAR
NiMH AAA: • Sanyo: HR-4U
• Varta: VH 551 AAA
Charging the batteries
The battery cells are not charged when supplied. To charge the
batteries, you need to place the handset on to the charging unit.
The charging process is indicated by the flashing battery symbol
on the handset display.

Applications

Your Swatch Cordless II supports the multi-vendor DECT GAP
protocol. To be able to register it on a foreign base station, it must
support the GAP protocol. The following functions are available in
this connection when operating on a first-generation Swatch
Cordless base station:
• internal call
• outgoing calls from the handset
• answering incoming calls
• registering and de-registering the handset
• internal calls from handset to handset
For more detailed information please refer to the Operating
Instructions for the Swatch Cordless II Base.
Approval
The SWATCH Cordless II has been approved in accordance with
EU Recommendation 91/263/EEC Telecommunication Transmis-
sion Equipment.
This equipment complies with the requirements of the EU
Recommendations.
G
UIDE
,
INSTRUCTIONS
• Sanyo: N-4U
• Panasonic: HHR55AAA
• Maxell: Ace HR-AAA