Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
The functions work the same as your dehumidifi er's touch controls.
1. Power button: On/Off
2. Fan speed button: High/ Low
3. On/Off timer button:
• In running mode: auto switch OFF
• in standby mode: auto switch ON.
4. Temperature display selector button (Celsius/ Fahrenheit): Press the º C/ º F
button to toggle between degrees Celsius and Fahrenheit.
5. Timer/ humidity button:
•
Used for adjusting the timer and the humidity.
•
The default display is room humidity.
•
When the "+" or "-" button is pressed, the set humidity is displayed and may be
adjusted. After 10 seconds, the display will revert back to room humidity. The
remote operates within a range of 6 meters (16.4 ft.) from the receiver located
inside the main unit. Any obstruction between the receiver and remote may cause
signal interference, limiting the ability to program the main unit.
BATTERIES: Remove the cover on the back of the remote controller and insert the batteries with the (+) and (-) poles
pointing in the proper direction.
CAUTION: Use only AAA or IECR03 1.5V batteries. Remove the batteries if the remote control is not used for one month
or longer. Do not attempt to recharge the supplied batteries. All batteries should be replaced at the same time. Do not
dispose of the batteries in a fi re, as they may explode.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc), or rechageable (ni-cad, ni-mh, etc.) batteries.
CAN ICES-3 (B) / NMB-3 (B)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician for help.
Changes or modifi cations not approved by the party responsible for FCC compliance could void the user's
authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
6
Publicité
