Publicité
Les langues disponibles
Les langues disponibles
START OPERATION
1. Place the product in an upright position on a fl at, stable, and heat-resistant
surface. Make sure there is nothing fl ammable or heat sensitive within 39
inches (100 cm). Operating the product in any other position could cause a
hazard.
2. Insert the plug into a suitable wall socket. The dehumidifi er is suitable for
operating on an electrical supply having the same voltage as that shown on its
rating label.
3. Make sure the water tank is correctly positioned. After switching the unit on for
the fi rst time, if the "Bucket Full" light illuminates, pull out the water tank and
check that the "fl oat" lever is able to move freely. Then return the water tank to
the correct position (Fig. 1).
CONTROL PANEL
INSTRUCTIONS
NOTE: The control panel of the unit you purchased may be slightly different depending on the model number.
When you push the button to change operation modes, the unit will make a beeping sound to indicate that it is
changing modes.
1) POWER BUTTON: On/Off
2) FAN SPEED BUTTON: High/ Low
3) TIMER BUTTON: When the unit is operating, press
TIMER to set number of hours desired until the unit will
shut off. When the unit is in stand-by, press TIMER to set
the number of hours desired until the unit will turn on. Set
the timer from 1-24 hours. To cancel the timer, proceed as
above but set the "timer off" to zero (0) hours.
4) º C/ º F BUTTON: Press the º C/ º F button to toggle
between degrees Celsius and Fahrenheit.
5) Receiving Sensor
6) SET HUMIDITY/ CURRENT HUMIDITY DISPLAY:
When the unit is running, it displays the current humidity.
Press the UP or DOWN buttons to select the humidity
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
setting. The humidity is adjusted in increments of 5%
by each pressing of the button. The adjustable range is
within 30% RH (relative humidity) to 90% RH. 10 seconds
after setting the humidity, the display will change back to
showing the current humidity.
7) CURRENT TEMP/ TIMER SET DISPLAY:
When the unit is running, it displays the current tempera-
ture. Press the TIMER button to set the machine to shut
off automatically after a specifi ed amount of time. 10
seconds after displaying the timer, the display will change
back to showing the current temperature.
8) DEFROST LIGHT: When the temperature is low, the
unit enters defrost mode, and the defrost light illuminates.
9) BUCKET FULL LIGHT: When the water tank is full, the
bucket full light illuminates.
5
Publicité
