Ovation C-805FC Guide De Référence Rapide page 3

Replacing the Fuse
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
DMX Linking
The Ovation C-805FC will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Ovation C-805FC uses a 3- or 5-pin DMX data connection for its DMX personalities: ranging from 3CH to 31CH in
1-cell modes and 2-cell modes:
DMX-
VCW-CCT
1-Cell 3
2-Cell N/A
See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Ovation C-805FC uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Ovation C-805FC supports RDM protocol that allows feedback to make changes to some menu
map options. Download the User Manual from
Mounting
Before mounting this product, read the
weight of the product. For our Chauvet line of mounting clamps, go to http://trusst.com/productcategory/truss-clamps/.
Product Mounting Diagram
Ovation C-805FC QRG Rev. 5
QUICK REFERENCE GUIDE
RGB RGBA RGBAL
3 4
6 8
www.chauvetprofessional.com
Safety Notes. Make sure the mounting clamps are capable of supporting the
Omega Bracket
Overhead Mounting
RGBA
RGB EXT
EXT
5 8
10 15
Mounting Clamp
Safety Cable
Floor Mounting
RGBAL RGBAL
EXT Fine
9 10
17 19
for more details.
EN
RGBAL
FULL
10 17
20 31
2