Flex FX2131A Manuel De L'utilisateur page 17

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This Circular saw must be used only with the battery packs and chargers listed below:
2.5Ah 5Ah
FLEX FX0111 FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
SWITCH (FIG. 10)
To turn the tool "ON", press and hold the lock-
off button with your thumb, then squeeze the
trigger switch with your finger. Release the
lock-off button and continue to squeeze the
trigger for continued operation.
To turn the tool "OFF", release the trigger
switch, which is spring loaded and will return to
the off position automatically.
Your saw should be running at full speed
BEFORE starting the cut, and turned off only
AFTER completing the cut. To increase switch
life, do not turn switch on and off while cutting.
OPERATION INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
Fig. 10
-17-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FX0411 FLEX FX0421
Lock-Off Button
Trigger Switch