Toshiba 27A62 Mode D'emploi page 11

Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most VCR models,
and cable TV converters together, even if they are different brands. If
you will be using your TV with a Toshiba VCR, your remote control is
already programmed and ready to use. If you own different brands of
VCRs and/or converters, you first have to program your remote control.
(See "Programming the remote control for use with a VCR or a cable
TV converter" on page 12.)
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Using the remote control with a VCR or a cable TV converter
To control a Toshiba
VCR:
Press the VCR button
first. The buttons
shown to the right will
then control the VCR.
The rest of the buttons
will operate the TV as
usual.
Fast Forward
VCR CH
3L51501C/E P07-14 11
All manuals and user guides at all-guides.com
VCR
POWER TV VCR CABLE
Power
CH RTN
ENT
1 2 3
Enter
100
4 5 6
Channel
Numbers
7 8 9 0
CH +
VOL VOL
– +
MENU/
ENTER
CH –
EXIT RECALL TV/VIDEO FAV
PIP CH PIP CH
RESET CAP/TEXT 1/2 FAV
STILL LOCATE SWAP PIP
CODE MTS SLEEP MUTE
Play
PLAY
REW FF
Rewind
TV/VCR STOP PAUSE/STILL
TV/VCR
REC
VCR CH
Record
Stop
/
Pause/Still
Note:
This remote control's functions may or may
not operate your VCR or cable TV converter.
Refer to the owner's manuals supplied with
the equipment to see which features are
available. In addition, the original controllers
may have features not available on this
remote control. If you would like to continue to
use these features, you may want to use the
original remote control.
Caution:
• Dispose of batteries in a designated
disposal area. Do not throw batteries into a
fire.
• Do not mix battery types or combine used
batteries with new ones.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• If you do not intend to use the remote control
for a long time, remove the batteries.
To control a cable TV
converter:
Program the remote
control to recognize the
brand of your converter
(see "Programming the
remote control for use
with a VCR or cable TV
converter", on page 12).
Channel +/–
The buttons shown on
the right will control the
cable TV converter. Press
the CABLE button first.
11
4/6/2002, 12:48
Cable
POWER TV VCR CABLE
Power
CH RTN
ENT
1 2 3
Enter
100
4 5 6
Channel
Numbers
7 8 9 0
CH +
VOL VOL
– +
MENU/
ENTER
CH –
EXIT RECALL TV/VIDEO FAV
PIP CH PIP CH
RESET CAP/TEXT 1/2 FAV
STILL LOCATE SWAP PIP
CODE MTS SLEEP MUTE
PLAY
REW FF
TV/VCR STOP PAUSE/STILL
REC
VCR CH