Laurus LCA600 Notice D'utilisation page 118

are running is indicated by the number of
illuminated Cooking Zone Indicators.
The timer values for the Heater Timer and
the Minute Minder Timer can be displayed
by pressing , a Cooking Zone Indicator
will flash for the timer it is assigned to. If no
Cooking Zone Indicator flashes, the Minute
Minder Timer value will be shown on the
Timer Display.
All Heater Timers can be removed by
switching the appliance into S-Mode using
, however this will have no effect on the
Minute Minder Timer which will continue
counting down.
To remove a timer in Operation Mode,
first select the timer using the Activate/
Deactivate Timer Button until the desired
timer is displayed on the Timer Display. It
can then be removed in 2 ways:
• Decrease the value by pressing
"00" appears on the Timer Display
• Press and
seconds until "00" is shown on the Timer
Display.
Once a timer reaches "0", the level of its
corresponding heater will also set to "0".
The end of both the Heater Timer and
the Minute Minder Timer is indicated by
the buzzer sound, this can be stopped by
pressing any button.
Key Lock
The key lock function is used to set 'safe
mode' on the appliance and can only be
used in Operating Mode (B-Mode). The lock
function becomes active when the key Lock
button is pressed for at least 2 seconds.
This operation is acknowledged by a buzzer
and the Key Lock Indicator will flash to
indicate the heater is locked.
If the heater is locked, it will only be
possible to switch the appliance off by
pressing , all other buttons are blocked
and it will not be possible to make any
adjustments by pressing the buttons. If any
other button is pressed in the lock mode,
the buzzer will sound and the Key Lock
Indicator will flash.
Only the switch-off operation by pressing
is possible. However, if the appliance is
switched off, it can not be restarted again
without being unlocked.
Child Lock
The child lock function is used to lock
the appliance in a complicated multi-step
process. Child lock (and unlocking) is only
until
simultaneously for 0.5
available in the S-Mode.
First, must be pressed until the buzzer
sounds, then
simultaneously for at least 0.5 seconds,
but no longer than 1 second. Following
this, press
All four heater displays will show "L" as
confirmation.
If the minute minder timer is still running,
it will proceed until "00" is reached and
the timer will beep. After confirmation of
timer completion, the appliance will be fully
locked. None of the buttons can be used as
long as the appliance is locked.
Child lock can be deactivated by pressing
until the buzzer sounds. Then
must be pressed simultaneously for at least
0.5 seconds, followed by pressing
As confirmation for successful unlocking,
"L" will no longer be displayed.
Touch Control Safety Functions
The following safety functions are available
to avoid unintended operations.
Sensor Safety Cut-Off
Button monitoring is included to prevent the
appliance from unwanted button operation.
In cases where one or more buttons are
pressed for longer than 12 seconds, the
buzzer will sound for ten minutes to indicate
an incorrect operation. For example, an
object may be placed on a button, or there
could be a sensor failure and so on.
The safety switch-off will cause the hob to
go into S-mode and all heater displays will
flash "F". If there is no incorrect operation
EN - 16
and must be pressed
to activate the child lock.
and
only.