Connecting The Rescue Bridle; Installing The Handle; Placing The Handle; Closing The Container - Neo Container Lite 2.0 Mode D'emploi

EN

CONNECTING THE RESCUE BRIDLE

The rescue must be connected to the bridles either directly, if the rescue's own bridle
allows it, or with a 6 mm oval inox Péguet Maillon Rapide with a maillon sleeve.
When connecting it directly, check the knot is flat.

INSTALLING THE HANDLE

The handle must be installed in the central attachment of the pod, to respect the
bridle length during deployment.

PLACING THE HANDLE

The rescue must be installed with the bridles placed at the bottom of the container
and the handle on top.
20

CLOSING THE CONTAINER

Start by placing the slider at the closing loops. Then, insert the 2 wires of the handle in
the loops using a short cord and close the velcro over the handle. Remove the cord.
Close the 2 zippers until the end. The photos below show the various steps to follow.
In case of doubt on the rescue installation, contact your reseller.
EN
21