Safety Information; Rescue Installation; Installing The Rescue Bridles - Neo Container Lite 2.0 Mode D'emploi

EN

SAFETY INFORMATION

If you use our gear, you must be a certified paragliding, speedriding, or speedflying
pilot, with insurance, and you must accept the risks involved in the activity, including
injury or death. Only the pilot can assess weather conditions, the wind, the area, its
gear, and safety before flying. Your gear requires constant attention while used, as
well as maintenance. The misuse of NEO gear could increase these risks.
Under any circumstances, NEO SAS or the reseller of this gear can be held res-
ponsible in case of injury to themself or damage to third parties due to an accident,
regardless of the situation. Therefore, the user of this product is fully responsible for
its use. Any changes to this harness will make it non-complying and therefore inva-
lidate its certification. This NEO product is designed exclusively for solo paragliding.
In case of not understanding your gear or the sport in full, please contact the NEO
reseller or importer in your country.
Each country has its own rules and regulations for free flight. It is your responsibility
to know and comply with them.
18

RESCUE INSTALLATION

The container includes pre-installed rescue bridles. The photos below show the
rescue inside the container.

INSTALLING THE RESCUE BRIDLES

Before installing the rescue parachute in the container, it is necessary to install the
rescue halyards. To do this, simply pass the elastic band found in the protection
tunnels through the main loop of the rescue halyard on both sides. These elastic
loops allow the container to be attached in a flexible manner, so as not to take the
load instead of the front belt.
The photos below illustrate the technique.
EN
19