Publicité
Les langues disponibles
Les langues disponibles
Installation
1. The wireless cylinder has been produced according to DIN 18252 and is suitable for use in DIN-approved mortise locks.
Please note: Self-assembly may not be possible on safety doors!
2. Remove the old cylinder. To do this, open the door and unscrew the fixing screw (see fig. 1). Completely remove the fixing screw.
3. Insert a key into the old cylinder and turn the cam with the key so that you can remove the cylinder. The cam prevents the
cylinder from being removed when in the normal cylinder position.
4. Insert the wireless cylinder so that the knob is on the inner side of the door. The cam position must be set accordingly here
by turning the knob. If the cylinder becomes jammed in the hole, then the hole or cylinder clamps need to be reworked.
Never use a hammer to force the cylinder into the hole.
5. Fasten the wireless cylinder using the fixing screw and check that it locks properly.
Publicité
