How To Prepare The Machine For Operation; How To Install The Batteries - IVIE Clarke Focus Série Manuel De L'utilisateur

38722B
38722B
38720B
38722B
Figure #6a
38722B
Figure #6b
Page -42-
HOW TO PREPARE THE MACHINE
FOR OPERATION

How To Install The Batteries

The 28, 33 and 38 Focus machines use six 6-volt
batteries. The batteries are located in the battery
compartment under the recovery tank.
To Install the batteries, follow this procedure:
1. Turn key switch off.
2. Make sure both tanks are empty.
3. Disconnect the hoses from the recovery tank
(upper tank) & unplug the vac motor and float
switch.
4. Remove the tank support bracket.
5. Remove the recovery tank.
6. Place the batteries in the solution tank as
shown in figures 6a and 6b.
WARNING:
WARNING:
7. Connect the battery cables between
batteries and install long battery cable
assembly as indicated. See figure 6a and 6b.
8. Install the tank, reconnecting hoses and
plugging in vac motor and float switch
connectors. Install tank support bracket.
NOTE: Charge the batteries before using the
machine.
®
Clarke
Operator's Manual - FOCUS S28/L28/S33/L33/S38/L38 WB
EN
Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!