Jeep Phoenix Fat Manuel D'utilisation page 25

Lubricate the parts in question only after they have been properly cleaned and degreased. Then, remove any excess lubricant
if oily lubricants have been used.
The front and rear suspensions (where present) cannot be adjusted unless otherwise specified in this manual as they do not
require specific maintenance interventions; they only need to be checked to ensure they are working correctly and there is
no play.
The linings of the suspensions installed on the bike already include the lubricant (where present)needed to ensure their
correct operation and do not, therefore, require additional lubrication.
The product frame must be inspected regularly to exclude the presence of any signs of cracking and/or so-called "material
fatigue" so that any intervention required to reduce and/or eliminate the risk of damage and/or breakage can be promptly
performed.
Each part of the fastening mechanisms on the bike should be carefully inspected and a preventive and periodic general
check performed of the correct tightening of the self-tightening nuts and fastening screws which may lose their efficiency
through use and over time
CAUTION
All the controls must be checked to ensure they work correctly after every routine maintenance intervention.
Maintenance notes
Every maintenance job must take place with the battery disconnected.
During each maintenance phase operators must be equipped with the necessary accident prevention equipment. The tools
used for maintenance must be suitable and good quality.
Do not use petrol or flammable solvents as cleaning agents but always use non-flammable and non-toxic solvents. Limit the
use of compressed air as much as possible and protect yourself with goggles with side shields.
Never use naked flame as a means of lighting when carrying out checks or maintenance work.
After each maintenance or adjustment job ensure that no tools or foreign bodies remain inside the organs of movement of
the assisted pedal bike.
This manual does not provide in-depth information regarding disassembly and extraordinary maintenance, as these opera-
tions must always be carried out exclusively by the authorized dealer's Support Service personnel.
The Assistance Service is able to provide all the indications and to respond to all the requests to take care of and keep your
pedal-assisted bicycle perfectly efficient.
CAUTION
Cleaning
Cleaning the electrically power assisted cycle is not only a matter of decorum, but also allows any defects to be detected
immediately.
The battery must be detached and removed in order to wash the bike, preferably using a sponge and/or a soft cloth and wa-
ter, with the possible addition of a specific neutral detergent and taking particular care when handling the electronic parts.
It is strictly forbidden to aim pressurised water jets at the various electrical parts, the motor, display and battery. After
washing, it is important to dry all the washed components, as well as the frame and the braking surfaces with a second soft
cloth and/or dry completely with low pressure compressed air and check that no residual moisture has remained on the
electrical components.
If there are stains on the body of the scooter, wipe with a damp cloth. If the stains persist, apply neutral soap, brush out with
a toothbrush, then wipe with a damp cloth.
Do not clean the items with alcohol, petrol, paraffin or other corrosive or volatile chemical solvents to prevent severe
damage.
DANGER
All the cleaning operations of the electrically power assisted cycle must be performed with the battery removed.
Water seeping into the battery may cause damage to internal circuits and risk of fire or explosion. Should you suspect that
water may have entered the battery, stop using the battery immediately and return it to your dealer's after-sales service for
checking.
24