Casselin CBINPP100 Mode D'emploi page 13

3. TRANSPORT, PACKAGING AND STORAGE
3.1 Inspection after transport
Checking for damage and the completeness of the device must be carried out upon receipt of the package.
In the event of identification of damage due to transport, refuse or accept the delivered product only with
reservations *. A complaint detailing the defects observed must then be made. The collection of damages is
only possible in the event of a complaint formulated within the prescribed time limits, ie 24-48 hours at most.
• written on the carrier's delivery papers or digital.
3.2 packaging
The packaging of the device must be kept in case of moving, or for a return to the after-sales service. The
inner and outer packaging must be completely removed before using the device. The standards in force in
your country concerning environmental protection must be observed before destroying the packaging.
3.3. Storage
WARNING
The device can be kept in stock, but only in its original, closed packaging.
Storage can be carried out in accordance with these conditions:
• Storage in a dry and non-humid place
• Sheltered from the sun
• Control of the stock greater than 2 months (general condition of the device and all the elements constituting
it)
• No material shaking
• Storage in a closed room and not outside.
4. EQUIPMENT CHARACTERISTICS
* Subject to change
Model
Electrical data
Temperature range
Dimensions
Weight
Model
Electrical data
Temperature range
Dimensions
Weight
CBINPP100
2000 W / 230 V / 50-60 Hz
30 ° C - 70 ° C
W 1000 x D 600 x H 900 mm
54 Kg
CBINPP150
2800 W / 230 V / 50-60Hz
30 ° C - 70 ° C
W 1500 x D 600 x H 900 mm
74 Kg
CBINPP120
2000 W / 230 V / 50-60 Hz
30 ° C - 70 ° C
W 1200 x D 600 x H 900 mm
61 Kg
CBINPP180
2800 W / 230 V / 50-60 Hz
30 ° C - 70 ° C
W 1800 x D 600 x H 900 mm
86 Kg
EN