Applications; Safety Notes - Monacor WSA-20BT Mode D'emploi

DC 5 V
Bluetooth Receiver
These instructions are intended for users
without any specific technical knowl-
edge . Please read the instructions care-
fully prior to operation and keep them
for later reference .
1 Overview
1 Jack DC 5 V for power supply via the
power supply unit provided
2 Receiving antenna
3 Audio output with line level
(6 .3 mm jack)
4 Button PAIR for the pairing mode
The illuminated ring of the button is a
status indication:
flashing: No device is paired with the
WSA-20BT .
lighting: The WSA-20BT is paired with
a Bluetooth device .

2 Applications

The Bluetooth receiver WSA-20BT is
used for wireless connection between a
Bluetooth signal source (e . g . notebook,
smartphone, tablet PC) and an audio
system . Thus, audio files replayed on the
Bluetooth signal source can be repro-
duced via the audio system connected
to the WSA-20BT .
6
ANT
1 2
PAIR
BAL
UNBAL
OUTPUT
LEFT
3

3 Safety Notes

The units (receiver and power supply
unit) correspond to all relevant direc-
tives of the EU and are therefore marked
with .
WARNING The power supply unit
uses dangerous mains
voltage . Leave servicing
to skilled personnel only .
Inexpert handling may result in electric
shock .
•
The units are suitable for indoor use
only . Protect them against dripping
water and splash water, high air hu-
midity and heat (admissible ambient
temperature: 0 – 40 °C) .
•
Immediately disconnect the power
supply unit from the mains socket
1 . if the power supply unit or the re-
ceiver is visibly damaged,
2 . if a defect might have occurred af-
ter the unit was dropped or suffered
a similar accident,
3 . if malfunctions occur .
In any case the units must be repaired
by skilled personnel .
•
For cleaning only use a dry, soft cloth;
never use water or chemicals .
•
No guarantee claims for the units and
no liability for any resulting person-
al damage or material damage will
be accepted if the units are used for
RIGHT
4