SE Electronics BL8 omni Mode D'emploi page 4

Lastly, turn the capsule counter-clockwise and remove it.
Turn the replacement capsule clockwise to lock it.
Refasten the capsule-retainer screw.
Place the microphone's grille back on its base, and finish by replacing the exterior screw.
Mounting on a surface
Using screws, the BL8 omni can be mounted to a surface, wall, ceiling, or the lid of a grand piano. Open the
microphone as described in the section "Changing the capsule". The two mounting points are covered with
black stickers; remove them with a sharp tool.
Then use a sharp tool to punch through the underlying protective foil, and mount as desired with screws
(not included).
At last, please close the microphone as described in the section "Changing the capsule".
4