Engel MRFD-015D-E Mode D'emploi page 5

I N S T R U C T I O N S F O R U S E
C) Cunent Soulces.
1.1. Connocrion !o 22OV-24OV-, sOHz AC Mains. (Erc6pr MODEL MRFD-OIsD)
Your Eng6l rafrig€€tor ll|€y b€ connsctod 10 a standard domestic mains pow€r source. using the three-cor€ mains
lsäd provided. lßen *|e squ6r€ mould€d mai.Ls plug into tho right-händ sid€ of th€ input terminal housing on ths
refrigffator. S€{ rhe üonh6tat corüol knob to
"O"
{OFF} until th€ cunsrt has b€€n tumod on. Th€n, s6t rh6 üErmostar
conltol knob lo
'1-5'
8nd th€ grs€n lamp will light üp. Tum tho lomp.raturi6 control knob to the rsquir€d setting.
1.2. Connscrion ro 12V o. 24V DC B6üorira.
Ensurs that th€ b3ttgry voltag€ con€spon& whh th€ voltago ststed on th€ rstrig€r.tor l6b€1. lf ths voltage suppli€d
is roo high h will dam€g€ th€ inv6nsr. ll h is too lo\/ th€ cooling €fficisncy will tß r€dLrcad. th€ rünning rim€ will
incr€as€ and thus ths battery will be subj6cr6d to 6n incroased loading.
Set th€ lh6mostat conüDl knob to'O- {OFF}. Insert th€ squaro moulded DC plug into the left-hsnd sid6 of th€ input
terminal housjng on rhs rstrig€rstor. The oth€r 6nd of the DC cable hss an adäptor for automobito cigarstr€r tight€r
ff dssjr€d, you may replace this adaptor wth a convenlional conn€ctor. For 6x3mpl€, in tha car toor (TRUNK)
connection.may b€ mad€ into th€ availabl€ pow€r supply, using
'Scotchlok'
connoctoß, but you muat not tap into
cables having a cross+eciiort6l area less than 2,5 mm1 anct if such is ths cas6 you should routs a !€plrrte supply
dir€c,t from th€ fus€ pan€l-
CAUTIONT Päy dne ett€ntion to corect polaity: th6 inn6r contact of th€ cigarotto ligl €r sockBt adsptoa muBt b6
connscted to the pGitivs supply, whilst the out6r ln€gativo) cont€ct is conn€ctod to eanh. Noarly sll mod€m whi-
clss are wired on the negadvsearth system, but the.a may still b€ old6l v€hicl* and imponsd on€ wh€tD th€
positrve eanh system is 6mploy6d,
O saloty Davicos
2.1. Polarity Gutrd for OC Aafiory Op€.arion.
Wh6n incorroct polärity b€ appli€d, the fuss blows Prevsnting damag€ to th€ inven6r. In this cas€, cor€ct polerity.
Th6n,replac6 lhe sp€cial th€rmal fus610A. (5€6 Fig.1)
Should incongct poladty be appli€d, the gre6n power lamp will nor light and th€ rsfrigorator willnot op€rats.
Following corecion of the curent supply,tho gr€en power lafip willligtt up and normal op€.ation witt b€ r6umed
However, if the gre€n power lamp does not light,this indicates a pocsible invsrt€r dsf€ct, and us6rs ar€ .dvissd to
contact thair Ensel daalsr for ssrvice. (See Fig.l)
O Insrallation and Ope.ation.
The refigerator should be sat in a convonisnt dry location, wh6r6 it is not subiected to splashing trom water o. oth6r
liquids or to radiant oi conduded heät f.om hot pipes, warm air outloG, cookers stc. Also ensure thar it is not etpo-
sed to direct sunshins. Ahhough ca.€ is taken to ensure that €n961 .sf.igsratoG leave th€ fadory in a clean condition
users are r€commendsd to wpe our the interior with a clean damp cloth, followed by dryjng with a clsan dry clorh,
before using a refrigsräto. for ths first time.
The thermostat control knob ssrves the dual purpose of governing AC and DC operation. The lh€rmo6tat conrrol
knob serves The purpose of govelning DC op€Etion {For MODEL MFFD-O15D only)
Vlrhen turngd as far possible in an anticlockwise di€ction th€ setriflg is 1 {REF).
When turned as far as possible in a clockwise dar€ction, rhe s6tting js "5", or {MAX).
This cofissponds to a deep freeze tempe€lure of approximatoly -18 C.
Dap€nding upon the prevailing ambisnt temperaturs, tha r6f ger€tor should initially b€ run for 30 to 45 minutes at
the 5 sotting, whsn starting froni an uncooled star€. Then turn rhe conrrol änticlockws€ to maintain th€ desiöd
iemerature within th6 calinet. le.g. the r6ng€ b€tween +4 and +9'C is id6al for rhe storage ol most too& normally
*spt in refrisoratoE).
In the cas€ of rhe
_buih-in-
model it is a r€qunsment that a ventilation ap€rtura of ät l6st 32ocrnt {5O squar€ inchss)