DURABLE 5082 Informations D'utilisation Et D'entretien page 19

Risk of personal injury due to injuries from cuts!
• Incorrect handling of cutting tools can cause injuries.
– Cut the two pieces from the noise-damping tape (4) as shown in the figure.
▶ see image 4
– Peel off the backing from the noise-damping tape and stick the larger pieces on the bottom
of the drawer (2) as shown.
▶ see image 5
– Peel off the backing from the noise-damping tape and stick the smaller pieces on the
drawer guides (3) as shown.
▶ see image 6
– Turn the monitor stand (5081) upside down.
▶ see image 7
– Fasten the drawer guides (3) in the slots needed for the desired height, as shown.
▶ see image 8
– Set the monitor stand (5081) upright.
▶ see image 9
– Place the felt insert (1) in the drawer (2).
Use
▶ see "Usage" on page 9
– Push the drawer on the drawer guides into the monitor stand (5081).
Disassembly
▶ see "Disassembly" from page 10
– If you wish to change the height of the drawer or dispose of the drawer, first disassemble
the drawer as shown.
Cleaning and maintenance
Risk of material damage from moisture!
• If water or cleaner comes into contact with the monitor or cables, this can cause an elec-
tric short circuit.
• Unplug the monitor from the power supply before cleaning. Clean the product with a
moist cloth, without allowing moisture to come into contact with the monitor.
Risk of material damage!
• Aggressive cleaners or sharp objects can damage the surfaces.
• Do not use sharp objects, abrasive or aggressive cleaners, or solvents. Clean the product
with a moist cloth.
⚠ WARNING
⚠ DANGER
ATTENTION
EN
English
19