Health Advice - Evolution COMPACT24HP Manuel D'utilisation

b. Smoking, using a naked flame or
producing sparks is strictly forbidden
whilst refuelling. Petrol is highly flammable
and its vapours are combustible.
c. Ensure that the fuel tap is turned 'off'.
This will ensure that fresh fuel does not 'flood'
the engines carburettor.
d. The engine must be turned 'off' and
allowed to cool before refuelling is
attempted. Inadvertent fuel spillage onto a
hot engine can result in the risk of fire.
e. Any fuel spills must be dealt with
immediately. If petrol contaminates any
clothing the operator must change clothes.
Do not rely on the fuel evaporating from the
clothes. Wash or launder the clothing when
the fuel has evaporated from the material.
f. The use of a funnel during refuelling is
recommended. Use of a funnel will minimise
the risk of fuel spillage.
g. Fill the tank with the correct grade of
unleaded fuel to a level approximately
half way up the fuel filter. Pour the fuel into
the tank carefully and do not try to fill the tank
completely. Pour the petrol slowly to avoid air
traps during filling that could cause fuel spillage.
h. Check the fuel tank cap, and replace as
soon as refuelling is completed. The cap
has a bayonet type connection. Check that it
is correctly installed and seated before slowly
turning on the fuel tap.
i. Check for any fuel leaks throughout the fuel
system. Do not attempt to start the engine if a
fuel leak is suspected. Any detected leak must be
repaired by a suitably qualified technician.
j. Observe all national and/or local
regulations about the storage and use
of petroleum products. All local bye laws
should be observed.

HEALTH ADVICE

WARNING: When using this machine,
dust particles will be produced. In some
instances, depending on the materials you
are working with, this dust can be particularly
harmful. You are advised to consider the risks
associated with the materials you are working
with and to reduce the risk of exposure. As
some materials can produce dust that may be
hazardous to your health, we recommend the
6
use of an approved face mask with replaceable
filters when using this machine.
You should always:
• Work in a well-ventilated area.
• Work with approved safety equipment,
such as dust masks that are specially
designed to filter microscopic particles.
thrown towards your eyes, which could result
in severe eye damage. Before beginning power
tool operation, always wear safety goggles or
safety glasses with side shield or a full face
shield where needed.
missing parts are replaced. Failure to follow
this rule could result in serious personal injury.
ADDITIONAL SAFETY RULES FOR
HULK COMPACTOR
a. Cordon off the work area. Members of the
public and unauthorised personnel should be kept
at a safe distance from compacting operations.
b. Be completely sure that you know how
to switch the machine 'off'. If you get into
difficulty during compacting operations it is
important that you can perform an emergency
shutdown of the machine.
c. Never leave the Hulk running and
unattended. The machine vibrates as soon
as it is started, and will also begin to move
forwards. The machine must be shutdown if it
is left unattended.
d. Always switch the engine 'off' before
moving the machine around the site. When
moving or transporting the machine the engine
must be switched 'off' and preferable cold,
with the fuel tap in the 'off' position.
e. As the Hulk engine becomes hot during
use ensure that you do not touch the
engine or allow any combustible material
or clothing to contact the engine during
use. Only touch or service a cold engine.
f. Never remove, alter or tamper with any of
the machines guards. The guards are specially
designed and fitted to provide you with the
www.evolutionpowertools.com
WARNING: the operation of any power
tool can result in foreign objects being
WARNING: If any parts are missing,
do not operate your machine until the