Dimensions - YORKVILLE Legacy Série Manuel De L'utilisateur

Yorkville
Note: The nx200s built-in stand mounting adapter can be used with Yorkville
SW-Teletube accessory to support small fullrange cabinets (approximately 16 kg /
35.25 lbs). The support tube can be adjusted up to it's full 5 foot 4 inch extension
safely as long as the nx200s is not inclined more than 10° (10 degrees).
WARNING: Larger/heavier cabinets should not be used with the stand mount!
Power Amplifier Power (internal)
Frequency response:
Input Impedance:
Speaker components:
The sleeves of the input are not grounded except when the input ground switch
is set to Gnd. Grounding is done through a 10-ohm protection device in order to
Clipping, average voice coil current, thermal
North American:
200
Specifications
200 Watts
50 Hz to 110 Hz
80 kohms
10 inch 2-ohm, 200 Watts
Input Connections
Tip: Positive
Ring(Shaft): Negative
Grounding
prevent damage due to miswiring.
Limiting
Maximum SPL
125 dB (50 Hz to 110 Hz)
Power Requirements
110VAC 60 Hz
260 Watts Maximum
European: 230VAC 50 Hz
260 Watts Maximum
Weight
54 lb. (24.5 kg)

dimensions

(WxDxH): 17.5 inch x 27 inch x14 inch
XX... 44.5x68.6x35.6 cm

S