innohaus ABC 30 Mode D'emploi page 12

The manufacturer is not liable for damage
resulting from improper or careless use.
• If you are using the unit for the first time,
please remove the protective film from the
display.
• The monitor can maintain the safety and
performance characteristics for a minimum
of 10.000 measurements or 3 years.
• Further documents which include information
for the Calibration of the device can be asked
at the service address.
• The device can be tested in case of supposed
inaccuracy every two years. Please contact
the nearest service address.
Cleaning and storing the device and cuff
To keep your digital blood pressure monitor in the
best condition and protect the unit from damage
follow the directions listed below:
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and
cuff under water, as this can cause liquid to
enter and damage the device and cuff.
• If you store the device and cuff, do not place
heavy objects on the device and cuff. Remove
the batteries.
• Clean your device and cuff carefully only
with a slightly moistened soft cloth and dry it
immediately with a soft dry cloth.
• When storing the device, make sure that no
heavy objects are placed on top of it.
• Do not fold the cuff tightly. If the unit is stored
near freezing, allow it to acclimate to room
temperature before use.
• Always store the unit in its storage case after
use.
• This unit may not meet its performance
specifications if stored or used outside of the
temperature and humidity ranges (see section
'13. Technical Specifications').
• Use the unit consistent with the instruction
provided in this manual.
12