Nakayama Pro EC1500 Mode D'emploi page 8

EN
OPERATION INSTRUCTIONS
This machine is a single-handed saw, suitable for single-handed operation. There is only one control handle. Don't get close to any moving part during operation.
Warning: If the saw chain rebounds, the saw chain will bounce towards the operator, which may cause serious or fatal injuries.
• Always cut at full speed.
• Do not cut with the head of the guide plate.
• When starting to cut, keep the chain saw at full speed and the guide plate vertical.
• Depending on the width of the guide, the head of the guide should expose the cut trees.
• Add the weight of the chain saw to the guide plate.
CLEANING INSTRUCTIONS
Chain saw cleaning:
1) Turn off the chain saw and cut off the power supply.
2) Wipe the chain saw body with a damp cloth.
3) Remove the sprocket guard.
4) Clean the periphery of the sprocket and the body with a damp cloth.
5) Use a softer brush when cleaning the battery pack charger.
6) Install the sprocket cover.
Cleaning the guide plate and the chain saw:
1) Turn off the chain saw and cut off the power supply.
2) Remove the guide plate and chain.
3) Use a soft brush to clean the rear groove of the guide plate.
4) Use a soft brush to clean the chain.
5) Install the guide plate and chain.
MAINTENANCE
Maintenance of sprocket:
1) The operator cannot disassemble the sprocket on their own.
2) If the sprocket is damaged or defective: please do not use the equipment and contact the dealer for replacement.
Maintenance of the guide plate:
1) If there are burrs on the edge of the guide plate groove, please polish it.
2) If you have any questions, please contact our dealer.
Maintenance of the grinding chain:
1) It is not advisable to use ordinary circular knives to polish the chain. Special circular knives must be used instead that are made specifically for polishing
chains.
8
WWW.NIKOLAOUTOOLS.GR