Filling The Boiler Tank Before Use - Reliable BRIO 500CC Guide D'utilisation

INSTRUCTIONS FOR USE

FILLING THE BOILER TANK BEFORE USE

• Unscrew the boiler tank fill cap (2), and use the funnel (28) provided to add
2.6L of water to the boiler tank.
• Tighten the boiler tank cap (2).
• Fit the required tool (see the "ATTACHMENTS" paragraph) to the steam handle.
Refill the water tank using the funnel (28) and a measuring cup with 1.9L of
water if the lower water level indicator (C) flashes during use.
SWITCHING ON
• Fold the power cord at the part closest to the female plug and insert the folded
part into the strain relief at the bottom of the cleaner. Due to the power of
the machine, a thicker cord is used and this may cause some difficulty when
inserting the cord into the strain relief. Insert the female plug into the socket on
the bottom right of the cleaner.
• Plug the power cord into the wall socket (the power indicator will begin to flash).
• Insert the steam hose into the connector (5) on the cleaner and make sure
that the arrow mark on the connector of the service hose faces upward when
plugging it in. You will hear a locking sound when the connector snaps in place.
Please make sure that the connector is fastened in place before use to avoid
danger.
• Press the power touch switch (A) on the control panel. The power indicator (B)
will stop flashing and come on. The water pump will start to fill with water and
you will hear pumping and vibration sounds.
• It takes approximately 4 minutes to preheat. You can use the trigger on the
handle to start releasing steam when all of the lights on the pressure indicator
(D) come on.
• If the low water indicator (C) flashes during use, please refill the water tank.
• Unplug the power cord from the wall socket after use. Empty the water in both
the water tank and boiler if the steam cleaner will not be used for a long period
of time. Unplug the service hose and store the cleaner in a cool, dry place.
WARNING:
1. There might be a few drops of water in the initial steam release. This is caused
from the condensation of steam traveled through the relatively cold hose.
2. A drop in steam pressure may occur in the initial steam release due to the
release of the air residue in the boiler.
3. There will be some noises caused by the vibration of the solenoid pump while
the boiler is being refilled during the operation of the cleaner.
4. The exhaust hole of the safety valve is located at the bottom of the cleaner.
07