Publicité
Les langues disponibles
Les langues disponibles
7
troubleshooting
Problem
Appliance is not functioning;
light does not work
Temperature inside the
larder is too high or too low
Appliance is excessively noisy
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the appliance.
Noises that can be easily remedied:
• Noise due to the fact that the appliance is not level – position the appliance using the front adjustable feet. If necessary,
place soft material under the rear wheels, particular in case of a tiled floor.
• Friction against other furniture – move the appliance.
• Grinding of drawers or shelves – remove the shelf or drawer and then place it back.
• Noise of colliding bottles – place the bottles apart.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compres-
sor (activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences
and flow of cooling liquid).
8
reversing the door opening
It is possible to change the door opening from either the left or the right side. To change the opening direction, please follow
these instructions.
Note: Before reversing the door swing, set the thermostat on OFF and unplug the appliance from the mains. Empty the
appliance, including the shelves before reversing the door opening.
• Remove the two screws at the back, holding the top panel to the appliance.
• Lift the top panel and remove it.
• Remove two bolts from the left top side and remove from the right top side the hinge with the three bolts (mind the
plastic parts between the hinge and the door).
• Remove the door by carefully lifting it from the bottom hinge. Put the door in a safe place.
• Remove and fit the plastic nog from the right side to the left side.
• Tilt the appliance 45°.
• Unscrew the two bolts and remove the bottom hinge. Install the bottom hinge on the opposite side und replace the bolts
in the provided holes.
• Replace the front leg on the right side with the bolts.
• Place the door against the appliance and make sure it is well fitted on the bottom hinge.
• Refit the hinge on the left top side (mind the plastic parts) with the bolts. Make sure the door is alligned with the outside of
the appliance.
• Set the appliance carefully upright.
• Screw the bolts back on the right top side.
• Remove the plastic part from the inside of the top panel and place it on the opposite side.
• Refit the top panel using the screws.
• Leave the appliance to stand for at least 3 hours before you insert the plug into the socket.
22
•
English
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or
vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards
Publicité
