Publicité
Les langues disponibles
Les langues disponibles
Assembly
• Slide the handle into the base of the
vacuum as shown in Figure A.
A
• Fasten the two parts together with the
supplied screw as shown in Figure B.
Ensure vacuum is assembled securely.
B
• Slide the nozzle (3) of the hand vac into
the bottom of the chassis (15) and push
the vac fully into the chassis until you hear
a snap as shown in Figure C.
• To remove, depress the hand vac release
button (14) and pull the hand vac out.
C
Charging the battery
• Before first use, the battery must be
charged for at least 4 hours.
• Plug the jack plug of the charger into
the charging socket of the tool as shown
in Figure D. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet.
WARNING:
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
NOTE: While charging, the charger may
This manual downloaded from http://www.manualowl.com
Before charging, be sure
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
WARNING:
battery at ambient temperatures below 50 °F
or above 104 °F.
D
Switching on and off
• To switch the appliance on, depress
the on/off button (1 or 12) as shown in
Figures E and F. The battery indicator
LED will illuminate and vacuum will begin
in the low-speed mode.
• Depress the button a second time to
engage the POWERBOOST mode. The
green LED will also illuminate, indicating
the vacuum is in the higher-speed mode.
• To switch the appliance off, depress the
button a third time.
E
4
Do not charge the
Publicité
