Publicité
Les langues disponibles
Les langues disponibles
4.
Place the bucket on the front pipe and left and right stays.
Place the rubber washer on the hole of the bucket and insert
the bolt from the top. Attach the flat washer and spring washer
in order to the bolt, and then tighten the nut from the bottom.
Tighten the rest of the bolts and nuts in the same way.
1
2
3
4
5
Fig.18
► 1. Bolt 2. Rubber washer 3. Flat washer 4. Spring
washer 5. Nut
5.
Securely tighten 4 bolts which were temporarily
tightened in step 3.
Removing the bucket
To remove the bucket, perform the installation proce-
dure in reverse.
Installing or removing the carrier
Optional accessory
Installing the carrier
1.
Take out the carrier from the box, and attach the
side rails and front rail to the base frame.
Fig.19
2.
Tighten 6 thumb nuts together with springs and
washers to fix the rails.
Fig.20
► 1. Thumb nut 2. Spring 3. Washer
3.
Place the carrier on the dump unit.
Insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
Fig.21
► 1. Bolt 2. Flat washer 3. Spring washer 4. Nut
Removing the carrier
To remove the carrier, perform the installation proce-
dure in reverse.
15 ENGLISH
1
2
3
1
2
3
4
Publicité
