Makita BTD043 Manuel D'instruction page 6

NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit or
socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
2
► 1. Sleeve 2. Bit
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
9 mm
(3/8")
1
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
.
N m
Standard bolt BTD043
.
(ft lbs)
25
(19)
20
(15)
15
(11)
10
(7)
5
(4)
0
0 0.5
Fastening time
High tensile bolt BTD043
.
N m
.
(ft lbs)
20(14)
18(13)
16(12)
14(11)
12(9)
10(7)
8(6)
6(4)
4(3)
2(1)
0
0
Fastening time
.
Standard bolt BTD063
N m
.
(ft lbs)
60
(44)
40
(29)
20
(14)
(1/4")
M6
0
0 0.5
Fastening time
6 ENGLISH
M10(3/8")
M8(5/16")
M6(1/4")
1 1.5
Seconds
M6(1/4")
1
Seconds
M12(1/2")
(M12)(1/2")
M10
(3/8")
M8
(5/16")
(3/8")
(M10)
(M8) (5/16")
(1/4")
(M6)
1.5
1
Seconds
(M10)
(3/8")
(M8)
(5/16")
(M6)
(1/4")
2
M6(1/4")
2