LOTRONIC KODA1400BT Manuel D'utilisation page 6

• Bad connection of power plug
• Volume turned down to the
minimum
• Speaker output selector not in
the correct position
• The volume is too loud
Distortion
• Incomplete speaker connection
Sound
• Incomplete input/output lead
only from
connections
one
• Left/right balance is off on one
channel
side
Specifications
Output power (RMS) ......................................................... 2 x 140W @ 4 Ohms
.......................................................................................... 2 x 100W @ 8 Ohms
THD .......................................................................................... <2% (30-20kHz)
Frequency response ..................................................................... 30Hz – 20kHz
Signal to noise ratio .......................................................... >77dB (A-weighted)
Rated input level/impedance................................................................. 500mV
FM Band: ................................................ 87.5 – 107.5MHz in steps of 0.1MHz
Rated load impedance .......................................................................... 4 Ohms
Power consumption ............................................................................... <130W
Power supply ................................................................ 220-240Vac ∼ 50/60Hz
Dimensions .......................................................................... 430 x 330 x 89mm
Net weight ............................................................................................... 5.3 kg
Notes:
1. The above specifications are only for reference
2. Design and specifications are subject to change for improvement without prior
notice
Accessories:
1x user manual
1x Remote control
Electric products must not be put into household waste. Please bring them
to a recycling centre. Ask your local authorities or your dealer about the way
to proceed.
©Copyright LOTRONIC 2015
• Connect the power cable
properly
• Turn the volume up to a
suitable level
• Select the correct speaker
output
• Reduce the volume to an
acceptable level
• Connect securely
• Connect securely
• Adjust the balance properly
6