Indel B SW CUBE 24 V Instructions D'utilisation page 33

Method for connection directly to the vehicle's
battery:
Identify the battery's positive terminal + and
1
negative terminal.
Connect the bridle's (G.1) power wiring eyelets to
the relative terminals (red wire + / black wire -).
2
It is advisable to leave the bridle (G.1)
permanently connected to the battery.
If necessary connect the power lead (G.2) to the
bridle (G.1) and to "CUBE".
3
The user is free to choose the lead's placement
(G.2) according to his requirements.
6.4 - TUBING
For operation, it is necessary to connect the tubing between "CUBE" and its various components.
"CUBE"'s flexible tubing (B) can extend and collapse in order to better suit the user's needs; this allows to place
"CUBE" in the most suitable position.
In placing the tubing it is, however, useful to follow a few simple suggestions in order to obtain the best
performance.
The tubing can be extended or shortened by simply polling them from the ends with your hands; they can also be
curved so as to achieve the best path.
In order to secure the tubing to "CUBE" and to
its other components (for example to the snorkel)
it is necessary to place the entrance nozzles (C)
to the ends:
- extend the tubing tip for a length equal to the
height of the entrance nozzle;
- fit the entrance nozzle to the tubing tip rotating it
counter-clockwise (as if you were screwing it on);
- stop when the tubing tip reaches the nozzle's
edge.
31