Publicité
Les langues disponibles
Les langues disponibles
4. ROUGH GRINDING
WARNING! Never use a cutting disc for rough
grinding applications.
This can cause bodily damage by using the mini
grinder for wrong applications.
WARNING! Do not switch the grinder on whilst
the disc is in contact with the workpiece. Allow the
disc to reach full speed before starting to grind.
Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and
minimum overloading, maintain an angle between
the disc and work surface of approximately 15°-30°
when grinding. Use caution when working into corners
as contact with the intersecting surface may cause the
grinder to jump or twist.
When grinding is complete allow the workpiece to cool.
(See Fig. F)
ORIGINAL INSTRUCTIONS
41
SAFETY AND OPERATING MANUAL
F
15
-30
o
o
Publicité
