Publicité
Les langues disponibles
Les langues disponibles
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Press the
button shortly to switch on the fixture. Switching off can be done by pressing and holding
for a longer time.
As soon as the green LED starts blinking release the
button.
As soon as the fixture has started up, you can switch between the DMX universe by shortly pressing
.
To restore factory settings, press the
button for 30 seconds.
BLACK OUT
Press <Blackout> to clear the remote control settings and turn off lights
AUTO
1. Press <AUTO> to turn on the color jumping effect.
2. Press <Blackout> to turn off the color jumping effect.
SOUND
1. Press <SOUND> to turn on Sound-Active mode
2. Press <Blackout> to turn off Sound-Active mode
SENSITIVITY
1. Press < SENSITIVITY > on the remote controller.
2. Press <+> or < - > to adjust sound sensitivity.
SPEED
Adjust the speed of color jump/fade/pluse effects
1. Press <SPEED> on the remote controller.
2. Press <+> or < - > to adjust color effects speed
STROBE
1. Press < STROBE > on the remote controller.
2. Press <+> or < - > to either increase or decrease the speed of the program .
3. Press <STROBE> to turn off the strobe.
%
1. Press <%> to turn on the color pluse effect.
2. Press <Blackout> to turn off the color pluse effect
Publicité
