HEIDENHAIN LC 415 14A Mode D'emploi page 2

3 Information based on the document type, the life-cycle phase of the product, and the
target group
The following documents must be read and observed by the stated target groups before mounting, initial configuration, or disposal
of the encoder.
Freely available documents are available at www.heidenhain.com/documentation.
Further documents are available upon Request.
Document
xpath-0
Operating Instructions
Operating Instructions LC 415 14A,
LC 485 14A,
LC 495 14A
xpath-0
Mounting Instructions
Mounting Instructions LC 4x5 – End
Block 14A
Mounting Instructions
Mounting Instructions MSL 41
xpath-0
Brochure
Interfaces of HEIDENHAIN Encoders
Brochure
Cables and Connectors
Brochure
Linear Encoders for Numerically
Controlled Machine Tools
Declaration of Conformity
Technical support
Measuring systems  +49 8669 31-3104
E-mail: service.ms-support@heidenhain.de
www.heidenhain.de
1375317 · Ver00 · 01
Document ID Life-cycle phase of the product/
Contents
xpath-1 xpath-2
1375317 Operation of the unit
xpath-1 xpath-2
743391 Mounting the product
894918 Mounting the product using the MSL 41
mounting spar
xpath-1 xpath-2
1078628 Interfaces and measuring methods
Electrical connection
Interface electronics
1206103 Cables and connectors for signal
transmission between the position
measuring system and the subsequent
electronics
571470 Technical features, operating conditions,
and mounting information
Specifications, dimension drawing
Electrical connection
Accessory
Website Conformity with applicable directives
Search for product
ID
XPath XPath XPath
✓ ✓ ✓
XPath XPath XPath
✓ ✓
✓ ✓
XPath XPath XPath
✓
✓
✓
✓ ✓
DR. JOHANNES HEIDENHAIN GmbH
Postfach 1260 · 83292 Traunreut