Beper BA.010 Manuel D'instructions page 9

All manuals and user guides at all-guides.com
EN
Vacuum sealer Use instructions
DEVICE'S FUNCTIONS
1) Dry food
To vacuum dry food push the button Dry and the blue working light turns on.
2) Moist food
To vacuum moist food push the button Moist and the blue working light turns on.
3) Stop
With Stop button the product stops working.
4) Sealing funcition
With Seal button the red working light turns on and the bag is sealed.
5) Vacuum and Sealing function
With Vac Seal button the product starts to vacuum and then seal the bag, green light turns on.
Cutter
This vacuum sealer has a cutter, to use it slide it on the bag in order to cut.
Put the roll in his case
Pass the bag in the slot and then let it slide to the desired length
Pull down the machine upper cover
Cut the bag with the cutter
Once you have sealed 5 bags continuously, allow the appliance to cool down for
about 1 minute. During this cool-down phase, you cannot start the appliance. After the
cool-down phase, you can use the appliance as normal.
The product is equipped with an additional vacuum system that allows, through an accessory tube, to vacuum
the air from specific vacuum containers, not included and sold separately.
Cleaning
Unplug the unit before cleaning it.
Do not immerse in water or other liquids
Do not use detergents or abrasives to clean the vacuum machine, they could ruin the product.
Do not use hard or sharp objects to remove adhesive from the welding wire. Otherwise the welding wire could
be damaged.
Clean the surface of the device with a slightly moistened cloth and a mild detergent.
Wipe off the upper and lower sealing rings as well as the press seal with a damp cloth. Make sure the device is
dry before using it again.
TECHNICAL DATA
Power: 140W
Voltage: 100-240V ~ 50/60 Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9