Scotts LB22020S Manuel Du Propriétaire page 4

TO TURN THE TOOL ON
Turn the rotary switch forwards (1). The further forward is turned,
the higher the motor speed. The blower is ready for use.
TO TURN THE TOOL OFF
To switch the blower off, turn the rotary switch fully to the rear (2),
until it locks in place.
①
WARNING: Do Not use the blower with any type of accessory or
attachment. Such usage might be hazardous.
If you drop the blower, carefully inspect it for damage. If the tube is
broken, housing cracked, or handles broken or if you see any
other condition that may affect the blower's operation, call our
customer service help line at 1-800-618-7474 for assistance.
To clean the tool, make sure the battery is detached from the unit,
then use only mild soap and a damp cloth. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by an
authorized service center or other qualified service organization,
always using identical replacement parts.
Problem
- Unit does not run
- Battery will not charge
②
Possible Cause
- Battery not making contact
- Battery not installed properly
- Battery not charged
- Battery not inserted into charger
- Charger not plugged in
- Surrounding air temperature too hot or too cold
Call us first with questions about operating or maintaining your cordless
blower at 1.800.618.7474 between 8:00 a.m. – 5:00 p.m. Eastern
Standard Time, or get assistance on scotts.americanlawnmower.com.
OPERATING
BLOWING
Blower can be used to clean corners, fences, walls, wooden areas
or beneath cars. Be careful how you point the jet of air as it could
move heavy material and cause injury or damage.
Turn the switch to on, point the jet of air in front of you and move
forward slowly to gather together the leaves or to move the leaves
from inaccessible areas.
Avoid collisions with hard objects which could damage your blower.
Keep bystanders and animals at least 5 m (15 feet) away from the
working area.
Make sure that the switch is in "OFF" position, the battery pack is
disconnected and all the rotating parts are at a standstill before
cleaning, carrying out inspections or moving from one place to
another.
Do not put part of your body such as hands and fingers in the
exhaust opening.
Do not switch the machine on in enclosed or poorly ventilated
spaces or in the presence of flammable and/or explosive
substances such as liquids, gas and powders.
WARNING: After battery has been fully depleted, make sure switch
is in the "OFF" position.
MAINTENANCE
CAUTION: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
Fertilizers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals Do not store the tool
on or adjacent to fertilizers or chemicals.
TROUBLESHOOTING
- Check battery is fully inserted
- Check that battery is securely connected to the blower
- Check battery charging requirements
- Insert battery into charger until red LED appears
- Plug charger into a working outlet
- Check current at receptacle by plugging in a lamp or other appliance
- Check to see if receptacle is connected to a light switch which turns
power off when you turn out the lights
- Move charger and tool to a surrounding air temperature of above 39
degree F (4 degree C) or below 104 degree F (40 degree C)
CALL US FIRST !!
4
LB22020S
Possible Solution